Dlp-H59 Provision Vc High-Order Path And Vc Low-Order Path Grooming Nodes - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 16 DLPs H1 to H99
From the Slot drop-down list, choose the slot where the circuit will originate.
Step 2
From the Port drop-down list, choose E1.
Step 3
If you are creating a VC low-order path circuit, choose the source E1 port from the E1 drop-down list.
Step 4
If you need to create a secondary source, for example, a path protection bridge/selector circuit entry
Step 5
point in a multivendor path protection configuration, click Use Secondary Source and repeat Steps
through
Step
Click Next.
Step 6
Step 7 From the Node drop-down list, choose the destination (termination) node.
Step 8 From the Slot drop-down list, choose the slot containing the destination card.
Step 9 Depending on the destination card, choose the destination port, VC high-order path, VC low-order path,
or E1 from the drop-down lists that appear based on the card selected in
page 5-2
paths, or DS-1s/E1s already used by other circuits. If you and a user working on the same network choose
the same port, VC high-order path, VC low-order path, port, or E1 simultaneously, one of you will
receive a Path in Use error and be unable to complete the circuit. The user with the incomplete circuit
needs to choose new destination parameters.
Step 10 If you need to create a secondary destination, for example, a path protection bridge/selector circuit exit
point in a multivendor path protection configuration, click Use Secondary Destination and repeat Steps
7 through
Click Next.
Step 11
Return to your originating procedure (NTP).
Step 12

DLP-H59 Provision VC high-order path and VC Low-order Path Grooming Nodes

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 In the Select Optimization area of the VC low-order path Matrix Optimization page, choose one of the
following:
•
78-19416-01
4 to define the secondary source. If you do not need to create a secondary source, continue with
6.
for a list of valid options. CTC does not display ports, VC high-order paths, VC low-order
9 to define the secondary destination.
This task provisions the VC high-order path and VC low-order path
grooming nodes.
None
DLP-H29 Log into CTC, page 16-43
The Circuit Creation wizard VC low-order path Optimization Matrix page
must be open.
As needed
Onsite or remote
Provisioning or higher
Create VC low-order path tunnel on transit nodes—This option is available if the circuit passes
through a node that does not have a VC low-order path tunnel or if an existing VC low-order path
tunnel is full. VC low-order path tunnels allow VC low-order path circuits to pass through ONS
nodes without consuming cross-connect card resources. VC low-order path tunnels can carry
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Step 8. See Table 5-1 on
16-77
1