Ntp-H181 Provision Node To Send Snmpv3 Traps; Ntp-H182 Manually Provision A Gne/Ene To Manage An Ene Using Snmpv3 - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 3 Turn Up a Node

NTP-H181 Provision Node to Send SNMPv3 Traps

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
SNMPv3. If you are already logged in, go to
In node view, click the Provisioning > SNMP > SNMP V3 tabs.
Step 2
Complete the following tasks as required:
Step 3
•
•
•
•
•
Stop. You have completed this procedure.
NTP-H182 Manually Provision a GNE/ENE to Manage an ENE
using SNMPv3
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
SNMPv3. If you are already logged in, go to
Go to network view.
Step 2
Double-click the ENE.
Step 3
78-19416-01
This procedure provisions a node to send SNMP v3 traps.
None
NTP-H148 Verify Card and SFP Installation, page 3-2
Required if you want to implement SNMPv3 on your network.
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
DLP-H282 Create an SNMPv3 User, page 18-81
DLP-H284 Create Group Access, page 18-82
DLP-H283 Create MIB Views, page 18-82
DLP-H287 Create Notification Filters, page 18-85
DLP-H285 Configure SNMPv3 Trap Destination, page
destination, use the IP address of the NMS, and the port number on which the NMS is listening for
traps.
This procedure describes how to manually configure a GNE/ENE to allow
the NMS to manage an ENE using SNMPv3.
None
NTP-H148 Verify Card and SFP Installation, page 3-2
Required if you want to implement SNMPv3 on your network.
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
Step 2.
18-83. When you configure an SNMPv3 trap
Step 2.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Before You Begin
on the node on which you want to set up
on the node on which you want to set up
3-15