Ntp-H101 Remove An In-Service Node From A Linear Adm - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 13 Add and Remove Nodes
When the fibers are connected properly, click Next. The Update Circuit(s) on Node-Name dialog box
Step 10
appears.
Note
Step 11 Click Next on the Update Circuit(s) on Node-Name dialog box.
The Force Traffic to Protect Path dialog box appears. This dialog box states that it is about to force the
traffic from the working to protect path for the terminal nodes.
Step 12 When you are ready to proceed, click Next.
Step 13 Follow each step as instructed by the wizard as it guides you through the process of refibering the
working path between nodes and forcing the traffic back to the working path. The final dialog box
informs you when you have completed the procedure.
Click Finish.
Step 14
Stop. You have completed this procedure.

NTP-H101 Remove an In-Service Node from a Linear ADM

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The 1+1 protection group must be unidirectional in order to delete a node from a linear ADM. If your
Note
1+1 protection group is bidirectional, see the
page 17-41
can then change the protection setting back to bidirectional.
Complete the
Step 1
remove the node.
Step 2 From the View menu, choose Go to Network View.
78-19416-01
The Back button is not enabled in the wizard. You can click the Cancel button at this point and
choose the Yes button if you want to cancel the Upgrade Protection procedure. If the procedure
fails after you have physically moved the fiber-optic cables, you must restore the fiber-optic
cables to the original positions and verify (through CTC) that traffic is on the working path of
the nodes before restarting the process. To check traffic status, go to node view and click the
Maintenance > Protection tabs. In the Protection Groups area, click the 1+1 protection group.
You can see the status of the traffic in the Selected Group area.
This procedure removes a single ONS 15600, ONS 15454, pr
ONS 15310-MA SDH node from a linear ADM that contains an
ONS 15310-MA SDH as an end node(s).
None
NTP-H29 Provision a Linear ADM Network, page 4-6
As needed
Onsite
Provisioning or higher
to change it to unidirectional. After you have removed the node from the linear group you
"DLP-H29 Log into CTC" task on page 16-43
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
"DLP-H137 Modify a 1+1 Protection Group" task on
at a node in the network where you will
Before You Begin
13-9