Cisco ONS 15310-MA SDH Procedure Manual page 144

Before You Begin
Including nodes and spans for a circuit ensures that those nodes and spans are in the working path
of the circuit (but not the protect path). Excluding nodes and spans ensures that the nodes and spans
are not in the working or protect path of the circuit.
Review Route Before Creation—Check this check box if you want to review and edit the circuit
•
route before the circuit is created.
To set the circuit path protection, complete one of the following:
Step 12
To route the circuit on a protected path, leave Fully Protected Path checked and continue with
•
Step
Fully protected paths might or might not have path protection path segments (with primary and
alternate paths), and the path diversity options apply only to path protection path segments, if any
exist.
To create an unprotected circuit, uncheck Fully Protected Path and continue with
•
If you selected Fully Protected Path in
Step 13
configuration, choose one of the following:
• Nodal Diversity Required—Ensures that the primary and alternate paths within path protection
portions of the complete circuit path are nodally diverse.
• Nodal Diversity Desired—Specifies that node diversity is preferred, but if node diversity is not
possible, CTC creates fiber-diverse paths for the path protection portion of the complete circuit path.
• Link Diversity Only—Specifies that only fiber-diverse primary and alternate paths for path
protection portions of the complete circuit path are needed. The paths might be node-diverse, but
CTC does not check for node diversity.
If you selected Fully Protected Path in
Step 14
dual-ring interconnect (DRI), check the Dual Ring Interconnect check box.
If you selected Using Required Nodes/Spans in
Step 15
continue with
Click Next.
a.
In the Circuit Route Constraints area, click a node or span on the circuit map.
b.
Click Include to include the node or span in the circuit. Click Exclude to exclude the node or span
c.
from the circuit. The order in which you choose included nodes and spans is the order in which the
circuit will be routed. Click spans twice to change the circuit direction.
Repeat Step
d.
Review the circuit route. To change the circuit routing order, choose a node from the Required
e.
Nodes/Lines or Excluded Nodes Links lists and click the Up or Down buttons to change the circuit
routing order. Click Remove to remove a node or span.
Step 16 If you are creating a VC high-order path circuit, skip this step and continue with
creating a VC low-order path circuit, click Next and complete the
path and VC Low-order Path Grooming Nodes" task on page
If you selected Review Route Before Creation in
Step 17
continue with
Click Next.
a.
Review the circuit route. To add or delete a circuit span, choose a node on the circuit route. Blue
b.
arrows show the circuit route. Green arrows indicate spans that you can add. Click a span arrowhead,
then click Include to include the span or Remove to remove the span.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
5-8
13. CTC creates a fully protected circuit route based on the path diversity option you choose.
Step 17.
c for each node or span you want to include or exclude.
Step 18.
Chapter 5 Create Circuits and VC Low-order Path Tunnels
Step 12 and the circuit will be routed on a path protection
Step 12 and the circuit will be routed on a path protection
Step 11, complete the following substeps. If not,
16-77.
Step 11, complete the following substeps. If not,
Step
Step 17. If you are
"DLP-H59 Provision VC high-order
78-19416-01
15.