Cisco ONS 15310-MA SDH Procedure Manual page 263

Chapter 13 Add and Remove Nodes
In the Confirm Clear Operation dialog box, click Yes.
d.
Complete
Step 17
Remove the fiber from protect ports of the target node.
Step 18
Connect the fiber between the protect ports of the two nodes on each side of the target node.
Step 19
Clear the Force switch:
Step 20
Next to Switch Commands, click Clear.
a.
In the Confirm Clear Operation dialog box, click Yes.
b.
In the Selected Group area, verify the following states:
c.
•
•
Repeat
Step 21
Step 22 Exit CTC.
Step 23 Relaunch CTC at any one of the nodes that were adjacent to the target node. The nodes will now show
the circuit status as DISCOVERED when checked.
Stop. You have completed this procedure.
78-19416-01
Step 12 to initiate a Force switch on the protect port.
Protect port - Protect/Standby
Working port - Working/Active
Step 13 through Step 16 to clear the switch on the other node.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Before You Begin
13-11