Dlp-H225 Set Up Snmp For A Gne - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 18 DLPs H200 to H299
Table 18-1
Parameter
Set OPR
Types
Intervals
Click Apply.
Step 4
Step 5 Return to your originating procedure (NTP).

DLP-H225 Set Up SNMP for a GNE

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 In node view, click the Provisioning > SNMP tabs.
In the Trap Destinations area, click Create.
Step 2
On the Create SNMP Trap Destination dialog box, complete the following fields:
Step 3
•
•
78-19416-01
Optics Thresholds Settings (continued)
Description
Setting the optical power received
establishes the received power level as
100 percent. If the receiver power
decreases, then the OPR percentage
decreases to reflect the loss in receiver
power. For example, if the receiver power
decreases by 3 dBm, the OPR decreases
50 percent.
Sets the type of alert that occurs when a
threshold is crossed. To change the type
of threshold, choose one and click
Refresh.
Sets the time interval for collecting
parameter counts. To change the time
interval, choose the desired interval and
click Refresh.
This procedure provisions simple network management protocol (SNMP)
parameters so that you can use SNMP network management software with
the ONS 15310-MA SDH.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite
Provisioning or higher
Destination Node Address—Enter the IP address of your network management system (NMS).
Community—Enter the SNMP community name. (For more information about SNMP, refer to the
"SNMP" chapter in the Cisco ONS 15310-MA SDH Reference Manual.)
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Options
Click SET.
TCA (threshold crossing alert)
•
Alarm
•
• 15 Min
1 Day
•
18-23