Dlp-H188 Delete A Roll; Dlp-H189 Cancel A Roll - Cisco ONS 15310-MA SDH Procedure Manual

Return to your originating procedure (NTP).
Step 16

DLP-H188 Delete a Roll

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 From the View menu, choose Go To Network View.
Click the Circuits > Rolls tabs.
Step 2
Click the rolled circuit that you want to delete.
Step 3
From the Tools menu, choose Circuits > Delete Rolls.
Step 4
In the confirmation dialog box, click Yes.
Step 5
Return to your originating procedure (NTP).
Step 6

DLP-H189 Cancel a Roll

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
17-84
This task deletes a roll. Use caution when selecting this option, traffic may
be affected. Delete a roll only if it cannot be completed or cancelled in
normal ways. Circuits may have a PARTIAL status when this option is
selected. See Table 17-5 on page 17-10
None
DLP-H29 Log into CTC, page 16-43
NTP-H129 Bridge and Roll Traffic, page 6-10
As needed
Onsite or remote
Provisioning or higher
This task cancels a roll. When the roll mode is Manual, you can only cancel
a roll before you click the Complete button. When the roll mode is Auto,
cancel roll is only allowed before a good signal is detected by the node or
before clicking the Force Valid Signal button. A dual or single roll can be
cancelled before the roll state changes to ROLL_COMPLETED.
None
DLP-H29 Log into CTC, page 16-43
NTP-H129 Bridge and Roll Traffic, page 6-10
As needed
Onsite or remote
Provisioning or higher
Chapter 17 DLPs H100 to H199
for a description of circuit statuses.
78-19416-01