Dlp-H83 Delete Alarm Severity Profiles - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 16 DLPs H1 to H99

DLP-H83 Delete Alarm Severity Profiles

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the View menu choose Go to Network View.
Step 1
To access the alarm profile editor from network view, click the Provisioning > Alarm Profiles tabs.
Step 2
To access the profile editor from node view, click the
Step 3
Provisioning > Alarm Profiles > Alarm Profile Editor tabs.
To access the profile editor from a card view, click the
Step 4
Provisioning > Alarm Profiles > Alarm Profile Editor tabs.
Click the profile you are deleting to select it.
Step 5
Click Delete.
Step 6
The Select Node/Profile Combination for Delete dialog box appears
Figure 16-22
Note
Note
Click the node name(s) in the Node Names list to highlight the profile location.
Step 7
Tip
78-19416-01
This task deletes a custom or default alarm severity profile.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
Select Node/Profile Combination For Delete Dialog Box
You cannot delete the Inherited or Default alarm profiles.
A previously created alarm profile cannot be deleted unless it has been stored on the node. If the
profile is visible on the Alarm Profiles tab but is not listed in the Select Node/Profile
Combinations to Delete dialog box, continue with
If you hold the Shift key down, you can select consecutive node names. If you hold the Ctrl key
down, you can select any combination of nodes.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
(Figure 16-22).
Step 11.
16-101