Dlp-H289 Automatically Configure The Snmpv3 Proxy Forwarder Table - Cisco ONS 15310-MA SDH Procedure Manual

In the SNMPv3 Proxy Forwarder Table area, click Manual Create.
Step 3
In the Manual Configuration of SNMPv3 Proxy Forwarder dialog box, enter the following information:
Step 4
•
•
•
•
•
•
•
Click OK to save the information.
Step 5
Return to your originating procedure (NTP).
Step 6

DLP-H289 Automatically Configure the SNMPv3 Proxy Forwarder Table

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In network view, click Provisioning > SNMPv3 tabs.
Step 1
Step 2 In the SNMPv3 Proxy Server area, complete the following:
•
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-86
Target IP Address—Target to which the request should be forwarded. Use an IPv4 or an IPv6
address.
Context Engine ID—The context engine ID of the ENE to which the request is to be forwarded. The
context engine ID should be the same as the context engine ID of the incoming request.
Proxy Type—Type of SNMP request that needs to be forwarded. The options are Read and Write.
Local User Details—The details of the local user who proxies on behalf of the ENE user.
User Name—Specify the name of the user on the host that connects to the agent.
–
Local Security Level—Select the security level of the incoming requests that are to be
–
forwarded. The options are noAuthNoPriv, AuthNoPriv, and AuthPriv.
Remote User Details—User to which the request is forwarded.
User Name—Specify the user name of the remote user.
–
Remote Security Level—Select the security level of the outgoing requests. The options are
–
noAuthNoPriv, AuthNoPriv, and AuthPriv.
Authentication
Protocol—Select the authentication algorithm you want to use. The options are NONE, MD5,
–
and SHA.
Password—Enter the password if you select MD5 or SHA.
–
Privacy—Enables the host to encrypt the contents of the message that is sent to the agent.
Protocol—Select NONE or DES as the privacy authentication algorithm.
–
Password—Enter the password if you select DES. The password should not exceed 64
–
characters.
This procedure creates an entry in the SNMPv3 Proxy Forwarder Table.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite
Provisioning or higher
Select the GNE to be used as the SNMPv3 proxy server from the drop-down list.
Chapter 18 DLPs H200 to H299
78-19416-01