Dlp-H170 Use The Reinitialization Tool To Clear The Database And Upload Software (Unix) - Cisco ONS 15310-MA SDH Procedure Manual

Click Go.
Step 6
Caution Before continuing with the next step, verify that the database to upload is correct. You cannot reverse
the upload process after you click Yes.
Review the information on the Confirm NE Re-Initialization dialog box, then click Yes to start the
Step 7
reinitialization.
The reinitialization begins. After the software is downloaded and activated, and the database is uploaded
to the 15310-MA-CTX card, "Complete" appears in the status bar and the 15310E-CTX-K9 (MA SDH)
card will reboot. Wait a few minutes for the reboot to complete.
After the reboot is complete, log into the node using
Step 8
Manually set the node name and network configuration to site-specific values. See the
Step 9
Up Name, Date, Time, and Contact Information" procedure on page 3-3
Name, Date, Time, and Contact Information" procedure on page 3-3
name, IP address, subnet mask and gateway, and IIOP port.
Step 10 Return to your originating procedure (NTP).
DLP-H170 Use the Reinitialization Tool to Clear the Database and Upload
Software (UNIX)
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Restoring a node to the factory configuration deletes all cross-connects on the node.
Caution
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
17-62
"DLP-H29 Log into CTC" task on page
This task reinitializes the ONS 15310-MA SDH using the CTC
reinitialization tool on a UNIX computer. Reinitialization uploads a new
software package to the 15310E-CTX-K9 card, clears the node database,
and restores the factory default parameters.
ONS 15310-MA SDH System Software CD, Release 9.1 and Release
9.2.
JRE 5.0 must be installed on the computer to log into the node at the
completion of the reinitialization. JRE 1.6 must be installed for Release
9.2. The reinitializtion tool can run on JRE 1.3.1_02, JRE 1.4.2, JRE
5.0, or JRE 1.6 (Release 9.2 only).
NTP-H102 Back Up the Database, page 14-2
NTP-H13 Set Up Computer for CTC, page 2-1
One of the following:
NTP-H14 Set Up TL1 session for Local Craft Connection to the
•
Node, page 2-3
NTP-H15 Set Up a CTC Computer for a Corporate LAN
•
Connection to the Node, page 2-4
As needed
Onsite or remote
Superuser only
Chapter 17 DLPs H100 to H199
16-43.
"NTP-H20 Set
and the "NTP-H20 Set Up
for information on setting the node
78-19416-01