Dlp-H172 Apply A Lockout; Dlp-H173 Clear A Lock-On Or Lockout - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 17 DLPs H100 to H199

DLP-H172 Apply a Lockout

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Multiple lockouts in the same protection group are not allowed.
Note
For a 1+1 optical protection group, only the protect port can be locked out.
Note
In node view, click the Maintenance > Protection tabs.
Step 1
In the Protection Groups list, click the protection group that contains the port you want to lock out.
Step 2
In the Selected Group list, click the port where you want to lock out traffic.
Step 3
Step 4 In the Inhibit Switching area, click Lock Out.
Step 5 Click Yes in the confirmation dialog box.
The Lock Out has been applied and traffic is switched to the opposite port. To clear the lockout, see the
"DLP-H173 Clear a Lock-on or Lockout" task on page
Note
Return to your originating procedure (NTP).
Step 6

DLP-H173 Clear a Lock-on or Lockout

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
78-19416-01
This task switches traffic from one port to another using a lockout,
which is a switching mechanism that overrides other manual switching
connections (Force or Manual).
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Maintenance or higher
Provisioning a lockout raises a LOCKOUT-REQ or an FE-LOCKOUTOFPR condition in CTC.
Clearing the lockout switch request clears these conditions.
This task clears a lock on or lockout.
None
DLP-H171 Apply a Lock-on, page 17-64
DLP-H172 Apply a Lockout, page 17-65
As needed
Onsite or remote
Maintenance or higher
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
17-65.
or
17-65