Ntp-H180 Provision Node For Snmpv3 - Cisco ONS 15310-MA SDH Procedure Manual

Before You Begin
•
•
•
•
•
•
Stop. You have completed this procedure.

NTP-H180 Provision Node for SNMPv3

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
SNMPv3. If you are already logged in, go to
Step 2 In node view, click the Provisioning > SNMP > SNMP V3 tabs.
Step 3 Complete the following tasks as required:
•
•
Note
•
Note
Stop. You have completed this procedure.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
3-14
DLP-H202 Add a Static TID to NSAP Entry to the TARP Data Cache, page
task as needed.
DLP-H204 Add a TARP Manual Adjacency Table Entry, page
DLP-H205 Provision OSI Routers, page
DLP-H206 Provision Additional Manual Area Addresses, page
DLP-H207 Enable the OSI Subnet on the LAN Interface, page
DLP-H208 Create an IP-Over-CLNS Tunnel, page
This procedure provisions the node to allow SNMPv3 access.
None
NTP-H148 Verify Card and SFP Installation, page 3-2
Required if you want to implement SNMPv3 on your network.
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
DLP-H282 Create an SNMPv3 User, page 18-81
DLP-H284 Create Group Access, page 18-82
A group named default_group is defined in the initial configuration. The default group has read
and notify access to the complete MIB tree.
DLP-H283 Create MIB Views, page 18-82
A view named full_view is defined in the initial configuration. It includes the complete MIB tree
supported on the node.
18-5—Complete this task as needed.
18-6—Complete this task as needed.
18-6—Complete this task as needed.
18-7—Complete this task as needed.
18-8—Complete this task as needed.
on the node on which you want to set up
Step 2.
Chapter 3 Turn Up a Node
18-4—Complete this
78-19416-01