Chapter 10
Change Node Settings
NTP-H84 Change SNMP Settings
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Step 2.
Complete the
Step 2
Perform any of the following tasks as needed:
Step 3
•
•
Step 4
Complete the
Stop. You have completed this procedure.
NTP-H85 Modify or Delete Communications Channel
Terminations and Provisionable Patchcords
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Deleting a DCC termination can cause you to lose visibility of nodes that do not have other DCCs or
Caution
network connections to the CTC computer.
Complete the
Step 1
Step 2.
As needed, complete the following tasks to modify data communication channel settings:
Step 2
•
78-19416-01
This procedure modifies SNMP settings for the ONS 15310-MA SDH.
None
NTP-H25 Set Up SNMP, page 3-12
As needed
Onsite or remote
Superuser only
"DLP-H29 Log into CTC" task on page
"NTP-H102 Back Up the Database" procedure on page
DLP-H150 Modify SNMP Trap Destination, page 17-52
DLP-H151 Delete SNMP Trap Destinations, page 17-53
"NTP-H102 Back Up the Database" procedure on page
This procedure changes or deletes RS-DCCs and MS-DCCs, and deletes
provisionable patchcords (PPCs) on the ONS 15310-MA SDH.
None
DLP-H52 Provision Section DCC Terminations, page 16-68
DLP-H53 Provision Line DCC Terminations, page 16-71
DLP-H49 Create a Provisionable Patchcord, page 16-66
As needed
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page
DLP-H152 Change a Section DCC Termination, page 17-53
16-43. If you are already logged in, continue with
16-43. If you are already logged in, continue with
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Before You Begin
14-2.
14-2.
10-7