DLP-H256 Install the UDC Cable on the ONS 15310-MA SDH
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1
Plug one end of the UDC cable into the UDC port at the rear of the 15310-MA SDH.
Step 2
Connect the other end to terminating equipment, such as a 64-Kbps codirectional ITU-T G.703
equipment interface or EIA/TIA-232-compliant equipment.
Table 18-17
Table 18-17
RJ-45 Pin Number
1
2
3
4
5
6
7
8
Step 3
Return to your originating procedure (NTP).
DLP-H257 Install the LAN Cable for the CTC Interface on the ONS 15310-MA SDH
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-58
This task installs the user data channel (UDC) cable on the ONS 15310-MA
SDH. A UDC circuit allows you to create a dedicated data channel between
nodes.
EIA/TIA-232 port cable, CAT-5 terminated with RJ-45
NTP-H150 Install the Shelf Assembly, page 1-5
As needed
Onsite
None
shows the serial cable pin assignments.
UDC Cable Pin Assignments
RS-232/64K Mode
TX +
TX –
RX +
—
—
RX –
—
—
This task installs the LAN cable to provide a 10/100 Mbps Ethernet
interface for CTC and TL1 provisioning.
Management LAN cable, CAT-5 terminated with RJ-45
NTP-H150 Install the Shelf Assembly, page 1-5
As needed
Onsite
None
Chapter 18
DLPs H200 to H299
78-19416-01