Dlp-H219 Hard-Reset The 15310E-Ctx-K9 Card Using Ctc - Cisco ONS 15310-MA SDH Procedure Manual

Note
Click Yes when the "Are You Sure?" dialog box appears.
Step 3
Step 4 Return to your originating procedure (NTP).

DLP-H219 Hard-Reset the 15310E-CTX-K9 Card Using CTC

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution Typically a hard reset causes a standard Telcordia protection switch of less than 50 ms. However, in the
following scenarios, hard-resetting the 15310E-CTX-K9 cards causes a traffic loss until the
15310E-CTX-K9 card fully resets:
If a 1+1 protection group is provisioned between optical ports located on the same 15310E-CTX-K9
card.
If both paths of a path protection configuration traverse through optical ports on the same
15310E-CTX-K9.
Before you reset the 15310E-CTX-K9 card, you should wait at least 60 seconds after the last
Note
provisioning change to avoid losing any changes to the database.
The 15310E-CTX-K9 cards do not support a real time clock with battery backup. Hence, during a card
Note
reset, the time is reset to default and the date starts at 1970 till you set the time/date again.
In node view, click the Inventory tab. Locate the 15310E-CTX-K9 card in the inventory pane.
Step 1
Click the Admin State drop-down list and select locked, maintenance. Click Apply.
Step 2
Click Yes in the "Action may be service affecting. Are you sure?" dialog box.
Step 3
The service state of the card becomes locked-enabled,maintenance. The card faceplate appears blue in
Step 4
CTC.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-16
For an ONS 15310-MA SDH, if there is any condition that prevents an errorless soft-reset, the
"Force Soft-Reset" message appears. You can choose to abort the soft-reset or proceed with the
forced soft-reset.
This task resets the 15310E-CTX-K9 card (ONS 15310-MA SDH) using
a hard reset. A hard reset temporarily removes power from the card and
clears all buffer memory.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Maintenance or higher
Chapter 18 DLPs H200 to H299
78-19416-01