Figure 4-3 Ons 15310-Ma Sdh Open-Ended Path Protection Configurations Fiber Connection Example - Cisco ONS 15310-MA SDH Procedure Manual

Before You Begin
Figure 4-3
Tx
Tx
Tx
Tx
Verify that the third-party cards or units to which the ONS 15310-MA SDH trunk ports are connected
Step 2
are the same STM-M rate as the ONS 15310 trunk ports. The third-party time slots must match the
ONS 15310 time slots to which they are connected. For example, if you are using an STM1 port, the
third-party vendor card or unit must have VCs 1-3 available.
Complete the
Step 3
already logged in, continue with Step 4.
Complete the
Step 4
ONS 15310-MA SDH cards/ports that are connected to another ONS 15310-MA SDH. (Alternatively, if
additional bandwidth is needed for CTC management, complete the
Terminations" task on page
the third-party equipment. The ONS 15310-MA SDH in
following cards/ports:
Nodes 1 and 6: Slot 4, Port 2-1 and Slot 3, Port 1-1
•
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
4-14
ONS 15310-MA SDH Open-Ended Path Protection Configurations Fiber Connection
Example
Rx
Slot 4
Port 2-1
Rx
Slot 3
Port 1-1
Node 2
Rx
Slot 4
Port 2-1
Rx
Slot 3
Port 1-1
Node 4
"DLP-H29 Log into CTC" task on page 16-43
"DLP-H52 Provision Section DCC Terminations" task on page 16-68
16-71.) Do not create a DCC termination for the card/port that connects to
Tx Rx
Slot 4
Port 2-1
Tx Rx
Slot 3
Port 1-1
Node 1
Third Party
Network
Tx Rx
Slot 4
Port 2-1
Tx Rx
Slot 3
Port 1-1
Node 6
at the node you are turning up. If you are
"DLP-H53 Provision Line DCC
Figure 4-3, has DCC terminations created at the
Chapter 4 Turn Up a Network
Tx Rx
Slot 4
Port 2-1
Tx Rx
Slot 3
Port 1-1
Node 3
Tx Rx
Slot 4
Port 2-1
Tx Rx
Slot 3
Port 1-1
Node 5
for the
78-19416-01