Ntp-H130 Manage Pluggable Port Modules - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 9 Change Port Settings
•
Note
According to site practice, complete the
Step 4
Stop. You have completed this procedure.

NTP-H130 Manage Pluggable Port Modules

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
PPMs.
Step 2 Click the Alarms tab:
a.
b.
c.
Step 3 As needed, complete the
If you preprovisioned a multirate SFP, skip this task and continue with
As needed, complete the
Step 4
STM1 or STM4 line rate.
As needed, complete the
Step 5
line rate on a multirate PPM.
As needed, complete the
Step 6
Stop. You have completed this procedure.
Step 7
78-19416-01
"DLP-H224 Change Optics Thresholds Settings for Optical Ports" task on page 18-22
To modify settings on the SDH VC high-order path tab, see the
Intermediate-Path Performance Monitoring" task on page
This procedure provisions, changes, and deletes Small Form-factor
Pluggables (SFPs), which are known as pluggable port modules (PPMs) in
Cisco Transport Controller (CTC). STM1, STM4, and multirate
(STM1/STM4/STM16) PPMs are compatible with the ONS 15310-MA
SDH. STM16 PPMs are compatible with the ONS 15310-MA SDH only.
Single-rate PPMs do not require provisioning or changing.
None
DLP-H16 Install SFP Connectors, page 16-19
Required
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
Verify that the alarm filter is not turned on. See the
page 16-107 as necessary.
Verify that no unexplained conditions appear on the network. If unexplained conditions appear,
resolve them before continuing. Refer to the Cisco ONS 15310-MA SDH Troubleshooting Guide.
Complete the "DLP-H223 Export CTC Data" task on page 18-20
information.
"DLP-H192 Provision a Multirate Pluggable Port Module" task on page
"DLP-H193 Provision the Optical Line Rate" task on page 17-88
"DLP-H194 Change the Optical Line Rate" task on page 17-89
"DLP-H195 Delete Pluggable Port Modules" task on page
"NTP-H102 Back Up the Database" procedure on page
"DLP-H88 Disable Alarm Filtering" task on
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Before You Begin
"DLP-H99 Enable
16-116.
at the node where you want to manage
to export alarm and condition
Step 4.
17-90.
14-2.
17-88.
to assign an
to change the
9-3