Ntp-H47 Create An Automatically Routed Optical Circuit - Cisco ONS 15310-MA SDH Procedure Manual

Before You Begin

NTP-H47 Create an Automatically Routed Optical Circuit

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
create the circuit. If you are already logged in, continue with
If you want to assign a name to the circuit source and destination ports before you create the circuit,
Step 2
complete the
Complete the following as necessary (you can provision Ethernet or packet-over-SDH (POS) ports
Step 3
before or after the VC high-order path circuit is created):
•
•
From the View menu, choose Go to Network View.
Step 4
Click the Circuits tab, then click Create.
Step 5
•
•
•
Click Next.
Step 6
Define the circuit attributes:
Step 7
•
•
•
•
•
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
5-32
This procedure creates an automatically routed optical circuit.
None
NTP-H36 Verify Network Turn-Up, page 5-4
NTP-H130 Manage Pluggable Port Modules, page 9-3
As needed
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
"DLP-H56 Assign a Name to a Port" task on page
To provision Ethernet ports for CE-100T-8 or CE-MR-6 circuits, complete the
Provision CE-100T-8 and CE-MR-6 Card Ethernet Ports" task on page
To provision POS ports for CE-100T-8 or CE-MR-6 circuits, complete the
CE-100T-8 and CE-MR-6 Card POS Ports" task on page
Circuit Type—Choose VC high-order path or VC low-order path.
Number of Circuits—Enter the number of optical circuits that you want to create. The default is 1.
If you are creating multiple circuits with the same source and destination, you can use autoranging
to create the circuits automatically.
Auto-ranged—This check box is automatically checked when you enter more than 1 in the Number
of Circuits field. Leave checked if you are creating multiple optical circuits with the same source
and destination and you want CTC to create the circuits automatically. Uncheck this check box if
you do not want CTC to create the circuits automatically.
Name—Assign a name to the circuit. The name can be alphanumeric and up to 48 characters
(including spaces). Circuit names should be 44 characters or less if you want the ability to create
monitor circuits. If you leave the field blank, CTC assigns a default name to the circuit.
Size—Choose the optical circuit size. If you are creating an VC high-order path circuit, the choices
are VC3, VC4, VC4-2c, VC4-3c, or VC4-4c. If you are creating a VC low-order path circuit, the
Size displays VC-12. You cannot change it.
Bidirectional—Leave the default (checked) for this circuit.
Create cross-connects only (TL1-like)—Check this check box if you want to create one or more
cross-connects to complete a signal path for TL1-generated circuits. Also, VC low-order path
tunnels and Ethergroup sources and destinations are unavailable.
State—Choose the administrative state to apply to all of the cross-connects in a circuit:
Chapter 5 Create Circuits and VC Low-order Path Tunnels
at a node on the network where you will
Step 2.
16-75. If not, continue with
17-85.
"DLP-H191 Provision
17-87.
(as needed)
Step 3.
"DLP-H190
78-19416-01