Ntp-H36 Verify Network Turn-Up; Ntp-H37 Create An Automatically Routed E1 Circuit - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 5 Create Circuits and VC Low-order Path Tunnels
c.
d.
e.
f.
g.
h.
i.
j.
Step 7 Repeat
Step 8 As appropriate, complete the circuit creation procedure listed in the
page
Stop. You have completed this procedure.

NTP-H37 Create an Automatically Routed E1 Circuit

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
create the circuit. If you are already logged in, continue with
78-19416-01
Click the Network tab. Verify that the IP address, subnet mask, default router, SOCKS proxy server,
and gateway settings are correctly provisioned. If not, make corrections using the
Change CTC Network Access" procedure on page
Click the Protection tab. Verify that protection groups are created as specified in your site plan. If
the protection groups are not created, complete the
15310-MA SDH, page 3-10.
Click the Security tab. Verify that the users and access levels are provisioned as specified. If not,
see the "NTP-H19 Create Users and Assign Security" procedure on page 3-3
information.
If Simple Network Management Protocol (SNMP) is used, click the SNMP tab and verify the trap
and destination information. If the information is not correct, see the
Settings" procedure on page 10-7
Click the Comm Channels tab. Verify that Section DCCs (RS-DCCs) or Line DCCs (MS-DCCs)
were created on the applicable STM-M ports. If DCCs were not created, see
Network" and complete the turn-up procedure appropriate for your network topology.
Click the Timing tab. Verify that timing is provisioned as specified. If not, use the
Change Node Timing" procedure on page 10-5
Click the Alarm Profiles tab. If you provisioned optional alarm profiles, verify that the alarms are
provisioned as specified. If not, see the
Profiles" procedure on page 8-6
Verify that the network element (NE) defaults file listed in the status area of the node view window
is correct. Refer to the "Network Element Defaults" appendix in the Cisco ONS 15310-MA SDH
Reference Manual document for more information about NE defaults.
Step 6 for each node in the network.
5-1.
This procedure creates an automatically routed E1 circuit, meaning that
CTC chooses the circuit route based on the parameters you specify and on
the software version.
None
NTP-H36 Verify Network Turn-Up, page 5-4
As needed
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
10-2.
NTP-H142 Create Protection Groups for ONS
to correct the information.
to make the changes.
"NTP-H60 Create, Download, and Assign Alarm Severity
to change the information.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Before You Begin
"NTP-H79
to correct the
"NTP-H84 Change SNMP
Chapter 4, "Turn Up a
"Before You Begin" section on
at a node on the network where you will
Step 2.
"NTP-H82
5-5