Dlp-H265 Set Up A Solaris Workstation For A Craft Connection To An Ons 15310-Ma Sdh - Cisco ONS 15310-MA SDH Procedure Manual

In node view, double-click the card where you want to view PM thresholds. The card view appears.
Step 1
Click the Provisioning > Thresholds tab. The subtab names vary depending on the card selected.
Step 2
Click Reset to Default.
Step 3
Click Yes in the Reset to Default dialog box.
Step 4
Verify that the PM thresholds have been reset.
Step 5
Return to your originating procedure (NTP).
Step 6
DLP-H265 Set Up a Solaris Workstation for a Craft Connection to an ONS
15310-MA SDH
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Log into the workstation as the root user.
Step 1
Check to see if the interface is plumbed by typing:
Step 2
# ifconfig device
For example:
# ifconfig hme1
If the interface is plumbed, a message similar to the following appears:
hme1:flags=1000842<BROADCAST,RUNNING,MULTICAST,IPv4>mtu 1500 index 2 inet 0.0.0.0 netmask
0
If a message similar to this one appears, go to
If the interface is not plumbed, a message similar to the following appears:
ifconfig: status: SIOCGLIFFLAGS: hme1: no such interface.
If a message similar to this one appears, go to
Plumb the interface by typing:
Step 3
# ifconfig device plumb
For example:
# ifconfig hme1 plumb
Configure the IP address on the interface by typing:
Step 4
# ifconfig interface ip-address netmask netmask up
For example:
# ifconfig hme0 192.1.0.3 netmask 255.255.255.0 up
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-64
This task sets up a Solaris workstation for a craft connection to the
ONS 15310-MA SDH.
None
NTP-H13 Set Up Computer for CTC, page 2-1
As needed
Onsite
None
Step 4.
Step 3.
Chapter 18 DLPs H200 to H299
78-19416-01