Dlp-H287 Create Notification Filters; Dlp-H288 Manually Configure The Snmpv3 Proxy Forwarder Table - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 18 DLPs H200 to H299

DLP-H287 Create Notification Filters

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 In node view, click the Provisioning > SNMP > SNMP V3 > Notification Filters tabs.
Step 2 Click Create.
In the Create Notify dialog box, enter the following information:
Step 3
•
•
•
•
Click OK to save the information.
Step 4
Step 5 Return to your originating procedure (NTP).

DLP-H288 Manually Configure the SNMPv3 Proxy Forwarder Table

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In network view, click Provisioning > SNMPv3.
Step 1
In the SNMPv3 Proxy Server area, complete the following:
Step 2
•
•
78-19416-01
This procedure creates SNMPv3 notification filters. The notification filters
are used to filter the notifications or traps, which should or should not be
transmitted to the management target.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite
Provisioning or higher
Filter Profile Name—Specify a name for the filter.
Subtree OID—The MIB subtree which, when combined with the mask, defines the family of
subtrees.
Bit Mask—A family of view subtrees. Each bit in the bit mask corresponds to a sub-identifier of the
subtree OID.
View Type—Select the view type. Options are Include and Exclude. Type defines whether the family
of subtrees that are defined by the subtree OID and the bit mask combination are included or
excluded from the notification filter.
This procedure creates an entry in the SNMPv3 Proxy Forwarder Table.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite
Provisioning or higher
Select the GNE to be used as the SNMPv3 proxy server from the drop-down list.
Select the Enable IPv6 Target/Trap check box if the nodes and the NMS stations are on an IPv6
network.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-85