Dlp-H281 Initiate A Path Protected Force Switch - Cisco ONS 15310-MA SDH Procedure Manual

From the View menu, choose Go to the Network View.
Step 1
Right-click a network span and choose Circuits.
Step 2
The Circuits on Span dialog box shows the SNCP circuits, including circuit names, locations, and a color
code showing which circuits are active on the span.
Initiate the span switch:
Step 3
a.
b.
c.
d.
Clear the switch:
Step 4
a.
b.
c.
d.
Note The ONS 15310-MA SDH and the 15310E-CTX-K9 card do not support SNCP switching for VC3
circuits containing BIP errors. The SF/SD alarm is not raised for VC3 circuits.
Return to your originating procedure (NTP).
Step 5

DLP-H281 Initiate a Path Protected Force Switch

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The Force Switch Away command overrides normal protective switching mechanisms. Applying this
Caution
command incorrectly can cause traffic outages.
From the View menu in node view, choose Go to Network View.
Step 1
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-80
Click the Perform SNCP span switching field and choose FORCE SWITCH AWAY from the
drop-down list.
Click Apply.
In the Confirm SNCP Switch dialog box, click Yes.
In the Protection Switch Result dialog box, click OK.
In the Circuits on Span dialog box, the Switch State for all circuits is Force. Unprotected circuits
will not switch.
Click the Perform SNCP span switching field and choose CLEAR from the drop-down list.
Click Apply.
In the Confirm SNCP Switch dialog box, click Yes.
In the Protection Switch Result dialog box, click OK.
In the Circuits on Span window, the Switch State for all SNCP circuits is CLEAR.
This task switches all circuits on an SNCP span.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
Chapter 18 DLPs H200 to H299
78-19416-01