Dlp-H292 Perform A Manual Span Upgrade On An Sncp - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 18 DLPs H200 to H299
•
Step 3 In the SNMPv3 Proxy Trap Forwarder Table area, click Auto Create.
In the Automatic Configuration of SNMPv3 Proxy Trap Forwarder dialog box, enter the following
Step 4
information:
•
•
Click OK to save the information.
Step 5
Return to your originating procedure (NTP).
Step 6

DLP-H292 Perform a Manual Span Upgrade on an SNCP

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Do not reach into a vacant slot or chassis while you install or remove a module or a fan. Exposed
Warning
circuitry could constitute an energy hazard. Statement 206
Complete the
Step 1
switch on the span that you will upgrade.
Step 2 Remove the fiber from both endpoint nodes in the span and ensure that traffic is still running.
Step 3 Remove the STM-N cards from both span endpoints.
For both ends of the span, in node view right-click each STM-N slot and choose Change Card.
Step 4
In the Change Card dialog box, choose the new STM-N card type.
Step 5
Click OK.
Step 6
Complete the
Step 7
new STM-N cards in both endpoints.
Verify that the transmit signal falls within the acceptable range. See
Step 8
card transmit and receive levels.
78-19416-01
Select the Enable IPv6 Target/Trap check box if the nodes and the NMS stations are on an IPv6
network.
Target Tag—Specify the tag name. The tag identifies the list of NMS that should receive the
forwarded traps. All GNE Trap destinations that have this tag in their proxy tags list are chosen.
Source of Trap—The list of ENEs whose traps are forwarded to the SNMPv3 Trap destinations that
are identified by the Target Tag.
This task upgrades SNCP spans to a higher optical speed. Repeat the
task to upgrade each span, and thus the entire ring, to the higher optical
rate. To downgrade an optical span in an SNCP ring, repeat this task but
choose a lower-rate card in
Higher-rate cards
Compatible hardware necessary for the upgrade
DLP-H29 Log into CTC, page 16-43
As needed
Onsite
Provisioning or higher
"DLP-H281 Initiate a Path Protected Force Switch" task on page 18-80
"NTP-H187 Install STM-N Cards and Connectors" procedure on page 1-20
Step
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
5.
to apply a Force
Table 1-2 on page 1-30
to install the
for STM-N
18-89