Dlp-H153 Change A Line Dcc Termination; Dlp-H154 Delete A Section Dcc Termination - Cisco ONS 15310-MA SDH Procedure Manual

Return to your origination procedure (NTP).
Step 6

DLP-H153 Change a Line DCC Termination

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Click the Provisioning > Comm Channels > MS-DCC tabs.
Step 1
Click the MS-DCC that you want to change.
Step 2
Click Edit.
Step 3
In the MS-DCC Termination Editor dialog box, complete the following as necessary:
Step 4
•
•
•
Step 5 Click OK.
Step 6 Return to your origination procedure (NTP).

DLP-H154 Delete a Section DCC Termination

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > Comm Channels > RS-DCC tabs.
Step 1
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
17-54
This task modifies a line data communications channel (MS-DCC). You
can also enable or disable OSPF and enable or disable the foreign node
setting.
None
DLP-H29 Log into CTC, page 16-43
As needed
Remote
Provisioning or higher
Disable OSPF on MS-DCC Link—If checked, Open Shortest Path First is disabled on the link.
OSPF should be disabled only when the slot and port connect to third-party equipment that does not
support OSPF.
Far End is Foreign—Check this box to specify that the MS-DCC termination is a non-ONS node.
Far end IP—If you checked the Far End is Foreign check box, type the IP address of the far-end node
or leave the 0.0.0.0 default. An IP address of 0.0.0.0 means that any address can be used by the far
end.
This task deletes a SDH Section DCC termination on the ONS 15310-MA
SDH.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
Chapter 17 DLPs H100 to H199
78-19416-01