Ntp-H65 Monitor Electrical Performance - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 7 Monitor Performance

NTP-H65 Monitor Electrical Performance

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
already logged in, continue to
In node view, double-click the ONS 15310-MA SDH electrical card. The 15310-MA SDH electrical
Step 2
cards are the E1_21_E3_DS3_3 and the E1_63_E3_DS3_3. The card view appears.
Click the Performance tab.
Step 3
Click the E1, DS3,or E3 tabs to view the PM parameters.
Step 4
The PM parameter names appear on the left side of the window in the Param column. The PM values
appear on the right side of the window in the Curr (current) and Prev-n (previous) columns. For PM
parameter definitions, refer to the Cisco ONS 15310-MA SDH Reference Manual.
Note
Stop. You have completed this procedure.
78-19416-01
This procedure allows you to view near-end or far-end performance on
electrical ports at specified time intervals to detect possible performance
problems.
None
Before you monitor performance, be sure you have created the
appropriate circuits and provisioned the card according to your
specifications. For more information, see
and VC Low-order Path Tunnels."
Settings."
As needed
Onsite or remote
Retrieve or higher
"DLP-H29 Log into CTC" task on page 16-43
Step
To refresh, reset, or clear PM counts, see the
page 7-2.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
at the node you want to monitor. If you are
2.
"NTP-H64 Change the PM Display" procedure on
Before You Begin
Chapter 5, "Create Circuits
and Chapter 9, "Change Port
7-3