Ntp- H166 Remove The Blank Sheet Metal Covers - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 1 Install the Cisco ONS 15310-MA SDH
NTP-H166 Remove the Blank Sheet Metal Covers
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Warning The covers are an integral part of the safety design of the product. Do not operate the unit without the
covers installed. Statement 1077
Use a Phillips screwdriver to remove the five screws holding each sheet metal cover in place.
Step 1
Figure 1-3
ONS 15310-MA SDH.
Figure 1-3
Step 2 Store the panels for later use. Attach the backplane cover(s) whenever EIA(s) are not installed.
78-19416-01
This procedure describes how to access the backplane by removing the
blank sheet metal covers. The backplane has two sheet metal covers (one
on either side).
#2 Phillips screwdriver
NTP-H150 Install the Shelf Assembly, page 1-5
Required
Onsite
None
shows the screw locations of the sheet metal covers installed on the A-side and B-side of the
Blank Sheet Metal Covers
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Blank sheet metal cover
installed on the B Side
Required Tools and Equipment
Blank sheet metal cover
installed on the A Side
1-9