Chapter 18 Dlps H200 To H299; Dlp-H200 Provision Osi Routing Mode - Cisco ONS 15310-MA SDH Procedure Manual

DLPs H200 to H299

DLP-H200 Provision OSI Routing Mode

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Do not complete this task until you confirm the role of the node within the network. It will be either an
Caution
ES or unlocked Level 1. This decision must be carefully considered. For additional information about
OSI provisioning, refer to the "Management Network Connectivity" chapter of the
Cisco ONS 15310-MA SDH Reference Manual.
Link State Protocol (LSP) buffers must be the same at all NEs within the network, or loss of visibility
Caution
might occur. Do not modify the LSP buffers unless you confirm that all NEs within the OSI have the
same buffer size.
Caution LSP buffer sizes cannot be greater than the LAP-D maximum transmission unit (MTU) size within the
OSI area.
The ONS 15310 primary NSAP address is also the Router 1 primary manual area address. To edit the
Note
primary NSAP, you must edit the Router 1 primary manual area address. After you enable Router 1 on
the Routers subtab, the Change Primary Area Address button is available to edit the address.
In node view, click the Provisioning > OSI > Main Setup tabs.
Step 1
Choose a routing mode:
Step 2
78-19416-01
C H A P T E R
This task provisions the Open System Interconnection (OSI) routing mode.
Complete this task when the ONS 15310-MA SDH is connected to
networks with third party network elements (NEs) that use the OSI
protocol stack for data communications network (DCN) communication.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite
Provisioning or higher
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18
18-1