Dlp-H45 Set Up External Or Line Timing - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 16 DLPs H1 to H99
•
•
•
Click Apply. A warning appears telling you that the port change will apply during the next CTC login.
Step 4
Click OK.
Step 5
To access the ONS 15310-MA SDH using the IIOP port, log out of CTC by choosing Exit from the File
Step 6
menu.
Log back into CTC. See the
Step 7
Return to your originating procedure (NTP).
Step 8

DLP-H45 Set Up External or Line Timing

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In the node view, click the Provisioning > Timing > General tabs.
Step 1
Step 2 In the General Timing area, complete the following information:
•
Note
•
78-19416-01
Default - Variable—Select this option if the ONS 15310-MA SDH nodes are on the same side of the
firewall as the CTC computer or if no firewall is used (default). This option sets the CTX listener
port to Port 57790. It can be used for access through a firewall if Port 57790 is open.
Standard Constant—Select this option to use Port 683, the CORBA default port number, as the CTC
computer listener port.
Other Constant—If Port 683 is not used, enter the IIOP port provided by your administrator.
Unavailable ports are listed in the "Management Network Connectivity" chapter of the
Cisco ONS 15310-MA SDH Reference Manual.
"DLP-H29 Log into CTC" task on page 16-43
This task defines the external or line SDH timing source for the
ONS 15310-MA SDH.
None
DLP-H29 Log into CTC, page 16-43
Required
Onsite or remote
Provisioning or higher
Timing Mode—Choose External if the ONS 15310-MA SDH derives its timing from a BITS source
wired to the port on the 15310; choose Line if timing is derived from the STM-M, E1-28, or E1-84
port. A third option, Mixed, allows you to set external and line timing references.
Because Mixed timing can cause timing loops, Cisco does not recommend its use. Use this mode
with care.
SSM Message Set—Choose a synchronization status messaging (SSM) message set. All
ONS 15310-MA SDH nodes can translate Generation 2 message sets, so choose Generation 2 if the
ONS 15310 is connected to other ONS 15310 nodes. Choose Generation 1 only when the ONS
15310 is connected to equipment that does not support Generation 2. If a node that has its SSM
Message Set set to Generation 1 receives a Generation 2 message, it maps the message down to the
next available Generation 1 message. The transit node clock (TNC) and ST3E become an ST3.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
for instructions.
16-61