Dlp-H163 Check The Network For Alarms And Conditions - Cisco ONS 15310-MA SDH Procedure Manual

In node view, click the Provisioning > Comm Channels > PPCs tabs. If you are in network view, click
Step 1
Provisioning > Provisionable Patchcords tabs.
Click the provisionable patchcord that you want to delete.
Step 2
Click Delete.
Step 3
In the confirmation dialog box, click Yes.
Step 4
Return to your originating procedure (NTP).
Step 5

DLP-H163 Check the Network for Alarms and Conditions

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 From the View menu, choose Go to Network View. Verify that all affected spans on the network map
are green.
Verify that the affected spans do not have active switches on the network map. Span ring switches are
Step 2
graphically displayed on the span with the letters "L" for lockout ring, "F" for FORCE ring, "M" for
MANUAL ring, and "E" for EXERCISE ring.
A second verification method can be performed from the Conditions tab. Click Retrieve Conditions and
Step 3
verify that no switches are active. Make sure the Filter button is not selected.
Click the Alarms tab and click Synchronize. Verify that no critical or major alarms are present, nor any
Step 4
facility alarms, such as LOS, LOF, AIS-L, AIS-P, SF, and SD. Make sure the Filter button is not selected.
If trouble is indicated (for example, a major alarm exists), resolve the problem before proceeding. See
Chapter 8, "Manage Alarms,"
Guide.
Step 5 Return to your originating procedure (NTP).
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
17-56
This task verifies that no alarms or conditions exist on the network.
None
DLP-H29 Log into CTC, page 16-43
As needed
Remote
Retrieve or higher
or, if necessary, refer to the Cisco ONS 15310-MA SDH Troubleshooting
Chapter 17 DLPs H100 to H199
78-19416-01