Dlp-H260 Route Cables; Dlp-H264 Clear All Pm Thresholds - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 18 DLPs H200 to H299
Return to your originating procedure (NTP).
Step 6

DLP-H260 Route Cables

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
As needed, install a tie-bar or other strain-relief device, according to local site practice.
Step 1
Caution You must provide some type of strain relief for the ONS 15310-MA SDH cabling.
Step 2 Route the cables to the appropriate side of the shelf assembly according to local site practice.
Step 3 Secure the cables to the strain-relief device using tie-wraps or other site-specific methods.
Step 4 Label all cables at each end of the connection to avoid confusion with cables that are similar in
appearance.
Step 5 Return to your originating procedure (NTP).

DLP-H264 Clear All PM Thresholds

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Pressing the Reset button can mask problems if used incorrectly. This button is commonly used for
Caution
testing purposes.
78-19416-01
This task routes electrical, optical, alarm, and timing cables away from the
ONS 15310-MA SDH. You can install optional tie-bars specifically
designed for the ONS 15310-MA SDH.
Tie-wraps or other securing devices, according to local practice
Tie-bar(s)
NTP-H158 Install the Electrical Cables, page 1-27
NTP-H160 Install Optical Cables, page 1-29
NTP-H157 Install Wires to Alarm, Timing, Craft, LAN, and UDC Pin
Connections, page 1-26
As needed
Onsite
None
This task clears and resets all PM thresholds to default values.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Superuser only
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-63