Ntp- H187 Install Stm-N Cards And Connectors - Cisco ONS 15310-MA SDH Procedure Manual

Required Tools and Equipment
If protective clips are installed on the backplane connectors of the cards, remove the clips before
Note
installing the cards.
Install an Ethernet card (CE-100T-8, CE-MR-6, or ML-100T-8) in a traffic card slot:
Step 1
a.
b.
c.
Note
Verify the Ethernet card LED activity:
Step 2
a.
b.
When you log into CTC, verify that the card appears properly in CTC node view.
Step 3
Complete the
Step 4
cards.
As necessary, continue with the
Step 5
Stop. You have completed this procedure.
NTP-H187 Install STM-N Cards and Connectors
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
Warning
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
1-20
Open the card ejector.
Use the ejector at the top of the card and firmly slide the card along the guide rails until the card
plugs into the receptacle at the back of the slot.
Verify that the card is inserted correctly and close the ejector on the card.
The Ethernet cards are hot-pluggable, which means they can be inserted or removed without
turning off the power to the ONS 15310-MA SDH.
Verify that the red FAIL LED is off.
Verify that the green ACT LED is on.
"NTP-H159 Install and Remove SFPs" procedure on page 1-28
This procedure installs the optical cards (STM-1, STM1-8, STM-4,
STM4-4, STM-16, and STM-64, and MRC-12). The MRC-12 (multirate),
OC192SR1/STM64IO Short Reach (STM64-XFP Short Reach), and
OC192/STM64 Any Reach(STM64-XFP Any Reach) cards require Small
Form-factor Pluggables (SFPs/XFPs) to provide the fiber interface to the
cards. On all other optical cards, the fiber is plugged directly into the card.
Install according to site plan, if available.
STM-1, STM-4, STM-16, STM-64, and MRC-12 cards (as applicable)
NTP-H150 Install the Shelf Assembly, page 1-5
As needed
Onsite
None
"NTP-H155 Install the Electrical Cards" procedure on page
Chapter 1 Install the Cisco ONS 15310-MA SDH
if you are using CE-MR-6
1-23.
78-19416-01