Cisco ONS 15310-MA SDH Procedure Manual page 533

Chapter 18 DLPs H200 to H299
In node view, double-click the E1_21_E3_DS3_3 card, or E1_63_E3_DS3_3 card where you want to
Step 1
change line or threshold settings.
Click the Provisioning > E1 tabs.
Step 2
Depending on the setting you need to modify, click the Line, Line Thresholds, Elect Path Thresholds,
Step 3
or SDH Thresholds subtabs.
Note
Step 4 Modify the settings found under these subtabs by clicking in the field that you want to modify. In some
fields, you can choose an option from a drop-down list; in others you can type a value.
Click Apply.
Step 5
Repeat Steps
Step 6
For definitions of line settings, see
on page
For definitions of SDH threshold settings, see
Table 18-3
Table 18-3
Parameter
Port #
Port Name
78-19416-01
If you want to modify a threshold setting, it might be necessary to click the available directional,
type, and interval (15 Min, 1 Day) radio buttons and then click Refresh. This will display the
desired threshold setting.
4 and 5 for each subtab that has parameters you want to provision.
18-36. For definitions of the electrical path threshold settings, see
describes the values on the Provisioning > E1> Line tab for the E1 ports.
Line Options for E1 Ports
Description
Port number.
Port name.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Table 18-3. For definitions of line threshold settings, see
Table 18-6 on page
Options
1 to 28 (E1_21_E3_DS3_3; ONS 15310-MA
•
SDH only)
1 to 84 (E1_63_E3_DS3_3; ONS 15310-MA
•
SDH only)
User-defined, up to 32 alphanumeric/special
characters. Blank by default
See the "DLP-H56 Assign a Name to a Port" task on
page 16-75.
Table 18-4
Table 18-5 on page
18-37.
18-36.
18-33