Dlp-H195 Delete Pluggable Port Modules - Cisco ONS 15310-MA SDH Procedure Manual

In the Change To field, use the drop-down list to select the new port rate and click OK.
Step 5
Click Yes in the Confirm Port Rate Change dialog box.
Step 6
Return to your originating procedure (NTP).
Step 7

DLP-H195 Delete Pluggable Port Modules

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Verify that you can delete the PPM. You cannot delete a port on a PPM if it is in service, part of a
Step 1
protection group, has a communications channel termination in use, is used as a timing source, has
circuits, or has overhead circuits. As needed, complete the following procedures and task:
•
•
•
•
•
•
In node view, for the ONS 15310-MA SDH, double-click the 15310E-CTX-K9 card.
Step 2
Click the Provisioning > Pluggable Port Modules tabs.
Step 3
Step 4 To delete a PPM and the associated ports:
a.
b.
c.
Step 5 Verify that the PPM provisioning is deleted:
•
•
If you need to remove the SFP, complete the
Step 6
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
17-90
This task deletes PPM provisioning for SFPs on the ONS 15310-MA SDH.
None
DLP-H29 Log into CTC, page 16-43
DLP-H192 Provision a Multirate Pluggable Port Module, page 17-88
As needed
Onsite or remote
Provisioning or higher
NTP-H143 Modify or Delete Card Protection Settings, page 10-4
NTP-H82 Change Node Timing, page 10-5
NTP-H85 Modify or Delete Communications Channel Terminations and Provisionable Patchcords,
page 10-7
NTP-H71 Modify and Delete Circuits, page 6-3
NTP-H72 Modify and Delete Overhead Circuits and Server Trails, page 6-4
DLP-H50 Change the Service State for a Port, page 16-67
Click the PPM line that appears in the Pluggable Port Modules area. The highlight changes to dark
blue.
Click Delete. The Delete PPM dialog box appears.
Click Yes. The PPM provisioning is removed from the Pluggable Port Modules area and the
Pluggable Ports area.
If the PPM was preprovisioned, CTC shows an empty slot in CTC after it is deleted.
If the SFP is physically present when you delete the PPM provisioning, CTC transitions to the
deleted state, the ports (if any) are deleted, and the PPM is represented as a gray graphic in CTC.
The SFP can be provisioned again in CTC, or the equipment can be removed, in which case the
removal causes the graphic to disappear.
"DLP-H17 Remove SFP Connectors" task on page
Chapter 17 DLPs H100 to H199
16-21.
78-19416-01