Ntp-H71 Modify And Delete Circuits - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 6 Manage Circuits
•
Step 4 In the VC low-order path Matrix Port Detail section, you can view details of the VC low-order path
Matrix Port usage:
•
•
•
•
Stop. You have completed this procedure.

NTP-H71 Modify and Delete Circuits

Purpose
Tools/Equipment
Prerequisite Procedures Circuits must exist on the network. See
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
circuit you want to modify. If you are already logged in, continue with Step 2.
As needed, complete the
Step 2
As needed, complete the
Step 3
As needed, complete the
Step 4
As needed, complete the
Step 5
As needed, complete the
Step 6
Timer" task on page
As needed, complete the
Step 7
As needed, complete the
Step 8
As needed, complete the
Step 9
As needed, complete the
Step 10
Stop. You have completed this procedure.
78-19416-01
VC12 Matrix—Provides the percent of the cross-connect synchronous transport signal (VC
low-order path) resources that are used. For the 15310E-CTX-K9, 128 VC4 ports are available.
Drop—Identifies the source slot, port, and VC high-order path.
Tunnel Name—Displays the VC low-order path tunnel name if the VC low-order path port is on a
VC low-order path tunnel origination or termination port.
% Used—Shows the percent of the matrix port that is used. Each matrix port can carry 21 VC12s
Usage—Shows the port usage. For example, if one VC high-order path carries 21 VC12 circuits, the
matrix port will show 21 of 21 are used.
This procedure modifies and deletes ONS 15310-MA SDH circuits.
None
Low-order Path Tunnels."
As needed
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
"DLP-H111 Change a Circuit Service State" task on page
"DLP-H112 Edit a Circuit Name" task on page
"DLP-H113 Change Active and Standby Span Color" task on page
"DLP-H115 Delete Circuits" task on page
"DLP-H241 Edit Path Protection Dual-Ring Interconnect Circuit Hold-Off
18-48.
"DLP-H115 Delete Circuits" task on page
"DLP-H180 Change a VCAT Member Service State" task on page
"DLP-H116 Add a Member to a VCAT Circuit" task on page
"DLP-H117 Delete a Member from a VCAT Circuit" task on page
for circuit creation procedures.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Before You Begin
Chapter 5, "Create Circuits and VC
at a node on the network containing the
17-15.
17-16.
17-19.
17-19.
17-17.
17-70.
17-20.
17-24.
6-3