Figure 16-11 Installing A Ds-3/E3 Cable With Minibnc Connectors - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 16 DLPs H1 to H99
Onsite/Remote
Security Level
Always use the supplied ESD wristband when working with a powered ONS 15310-MA SDH. For
Caution
detailed instructions on how to wear the ESD wristband, refer to the
(ESD) and Grounding
Note Cisco recommends you use Cisco-orderable miniBNC cables to ensure interoperability between the
cables and miniBNC connectors on the ONS 15310-MA SDH.
Place a miniBNC cable connector over the connector on the front of the ONS 15310-MA SDH.
Step 1
Figure 16-11
Figure 16-11
Position the cable connector so that the slot in the connector is above the corresponding notch on the
Step 2
ONS 15310-MA SDH connection point.
Gently push the connector down until the notch on the ONS 15310-MA SDH connector slides into the
Step 3
slot on the cable connector.
Turn the cable connector until the notch clicks into place.
Step 4
Return to your originating procedure (NTP).
Step 5
78-19416-01
Onsite
None
Guide.
shows how to connect a coaxial cable to an ONS 15310-MA SDH.
Installing a DS-3/E3 Cable with MiniBNC Connectors
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Cisco ONS Electrostatic Discharge
16-17