Ntp-H132 View And Manage Osi Information - Cisco ONS 15310-MA SDH Procedure Manual

Before You Begin
Complete database restore may be used only on a node that is removed from the network, and does not
Note
carry live provisioning traffic. This operation needs to be done by a live operator onsite, and must not
use a remote connection.
If you need to restore only the provisioning database (partial restore), do not check the Complete
Step 8
database (System and Provisioning) checkbox.
Click Ok.
Step 9
The Restore Database dialog box monitors the file transfer
Figure 14-1
Wait for the file to complete the transfer to the 15310E-CTX-K9 card. When the transfer completes, CTC
Step 10
switches to network view. Wait for the node to reconnect.
Stop. You have completed this procedure.

NTP-H132 View and Manage OSI Information

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note Additional information about OSI is provided in the "Management Network Connectivity" chapter of
the Cisco ONS 15310-MA SDH Reference Manual.
Step 1 Complete the
Step 2.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
14-4
Restoring the Database—In-Process Notification
This procedure allows you to view and manage Open System
Interconnection (OSI) including the End System-to-Intermediate System
(ES-IS) and Intermediate System-to-Intermediate System (IS-IS) routing
information tables, the TID Address Resolution Protocol (TARP) data
cache, and the manual area table.
None
NTP-H102 Back Up the Database, page 14-2
NTP-H13 Set Up Computer for CTC, page 2-1
NTP-H131 Provision OSI, page 3-13
As needed
Onsite or remote
Retrieve or higher can view OSI information. Maintenance or higher can
manage OSI information.
"DLP-H29 Log into CTC" task on page
Chapter 14
(Figure 14-1).
16-43. If you are already logged in, continue with
Maintain the Node
78-19416-01