Ntp-H64 Change The Pm Display - Cisco ONS 15310-MA SDH Procedure Manual

Before You Begin

NTP-H64 Change the PM Display

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
are already logged in, continue with Step 2.
As needed, use the following tasks to change the display of PM counts:
Step 2
•
•
•
•
•
•
•
•
•
•
Stop. You have completed this procedure.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
7-2
This procedure enables you to change the display of PM counts by
selecting drop-down list or radio button options in the Performance
window.
None
Before you monitor performance, be sure you have created the
appropriate circuits and provisioned the card according to your
specifications. For more information, see
and VC Low-order Path Tunnels."
Settings."
As needed
Onsite or remote
Retrieve or higher
"DLP-H29 Log into CTC" task on page 16-43
DLP-H89 Refresh PM Counts for a Different Port, page 16-107
DLP-H90 Refresh Electrical or Optical PM Counts at Fifteen-Minute Intervals, page 16-108
DLP-H91 Refresh Electrical or Optical PM Counts at One-Day Intervals, page 16-109
DLP-H92 Monitor Near-End PM Counts, page 16-109
DLP-H93 Monitor Far-End PM Counts, page 16-110
DLP-H94 Reset Current PM Counts, page 16-111
DLP-H95 Clear Selected PM Counts, page 16-112
DLP-H264 Clear All PM Thresholds, page 18-63
DLP-H96 Set Auto Refresh Interval for Displayed PM Counts, page 16-113
DLP-H97 Monitor PM Counts for Selected Signal Types, page 16-114
Chapter 7 Monitor Performance
Chapter 5, "Create Circuits
and Chapter 9, "Change Port
at the node that you want to monitor. If you
78-19416-01