Dlp-H123 Change The Node Name, Date, Time, And Contact Information - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 17 DLPs H100 to H199

DLP-H123 Change the Node Name, Date, Time, and Contact Information

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Changing the date, time, or time zone might invalidate the node's performance monitoring counters.
Note
In node view, click the Provisioning > General > General tabs.
Step 1
Change any of the following:
Step 2
•
•
•
•
•
•
•
•
•
•
See the
detailed field descriptions.
Click Apply.
Step 3
Return to your originating procedure (NTP).
Step 4
78-19416-01
This task changes basic information such as node name, date, time, and
contact information.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
General: Node Name
General: Contact
Location: Latitude
Location: Longitude
Location: Description
To see changes to longitude or latitude on the network map, you must go to network view
Note
and right-click the specified node, then click Reset Node Position.
Time: Use NTP/SNTP Server
Time: Date (M/D/Y)
Time: Time (H:M:S)
Time: Time Zone
Time: Use Daylight Saving Time
"NTP-H20 Set Up Name, Date, Time, and Contact Information" procedure on page 3-3
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
for
17-31