Rear Gate - If The Rear Gate Cannot Be Opened - Subaru Crosstrek 2020 Manual

Hide thumbs Also See for Crosstrek 2020:
Table of Contents

Advertisement

5. Hold the access key fob with the
buttons facing you, and touch the push-
button ignition switch with it.
When the communication between the
access key fob and the vehicle is com-
pleted, a chime (ding) will sound. At the
same time, the push-button ignition switch
turns to the "ACC" or "ON" position.
6. After the push-button ignition switch
turns to the "ACC" or "ON" position, while
depressing the brake pedal (all models)
and the clutch pedal (MT models), press
the push-button ignition switch.
NOTE
If the engine does not start even though
the above procedure was followed
precisely, contact your SUBARU dealer.
In case of emergency/Rear gate – if the rear gate cannot be opened
Rear gate – if the rear gate
cannot be opened
In the event that you cannot open the rear
gate by operating the rear gate opener
button, you can open it from inside the
cargo area.
1. Remove the access cover at the
bottom-center of the rear gate trim using
a flat-head screwdriver wrapped with vinyl
tape or a cloth.
2. Locate the rear gate open lever behind
the rear gate trim panel.
CAUTION
Never operate the rear gate open
lever with fingers because doing so
may cause an injury. Always use a
flat-head screwdriver or a similar
tool.
3. To open the rear gate, turn the lever to
the right position using a flat-head screw-
driver or a similar tool.
9-19

Advertisement

Table of Contents
loading

Table of Contents