Enable Optic-Info-Update Interval - Dell C9000 Series Reference Manual

Version
8.3.11.1
8.1.1.0
7.6.1.0
7.5.1.0
E-Series
Usage Information Users entering EXEC Privilege mode or any other configured privilege level can access
configuration commands. To protect against unauthorized access, use the enable
password command to configure a password for the enable command at a specific
privilege level. If no privilege level is specified, the default is privilege level 15. You can
also use the enable [level] command from a PE console to enter the privileged
mode.
Related enable password
Commands
privilege level.

enable optic-info-update interval

Enable polling intervals of optical information updates for simple network management protocol (SNMP).
C9000 Series
Syntax
enable optical-info-update interval seconds
To disable optical power information updates, use the no enable optical-info-
update interval command.
Parameters
interval seconds
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
Description
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Original command.
NOTE: If you are authorized for the EXEC Privilege mode by your role, you do not
need to enter an enable password.
— configures a password for the enable command and to access a
Enter the keyword interval then the polling interval in
seconds. The range is from 120 to 6000 seconds. The default is
300 seconds (5 minutes).
Control and Monitoring 86