Quality Of Service (Qos); General - Siemens SCALANCE XB-200 Configuration Manual

● Mirroring
Enable or disable port mirroring. You can configure other settings in "Layer 2 > Mirroring".
● Loop Detection
Enable or disable the loop detection function. This allows loops in the network to be
detected. You will find other settings in "Layer 2 > Loop Detection"
5.5.2

Quality of Service (QoS)

You should also refer to the chapter "Technical Basics", section "Quality of service
(Page 37)".
5.5.2.1

General

Transmission priorities
On this page, you can specify the priorities of different frames. In addition to this, depending
on the priority you can set the method according to which the processing order of the frames
is specified.
Description of the displayed values
The page contains the following boxes:
● Broadcast Priority
Specify the priority of broadcast frames. The switch sorts the frame into a Queue
according to this prioritization. You configure the assignment of the priority to a queue on
the page ""Layer 2 > QoS > CoS Map".
● Agent Priority
Specify the priority of agent frames. The switch sorts the frame into a queue according to
this prioritization . You configure the assignment of the priority to a queue on the page
""Layer 2 > QoS > CoS Map".
SCALANCE XB-200/XC-200/XP-200 Web Based Management
Configuration Manual, 07/2016, C79000-G8976-C360-04
Configuring with Web Based Management
5.5 The "Layer 2" menu
171