Load control
10.5 Service classes
10.5
Service classes
This section describes commands for configuring the assignment tables for service classes
and the Differentiated Services Code Point (DSCP).
10.5.1
show qos cos-map
Description
This command shows assignment table for service classes.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show qos cos-map
Result
The assignment table for service classes is displayed.
10.5.2
show qos dscp-map
Description
This command shows assignment table for DSCP.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
474
or
cli#
or
cli#
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07