Mitsubishi Electric GOT2000 Series Connection Manual page 152

2 - 68
2.9 MELSEC-WS
(3) Engineering software for MELSEC-WS and device representation of GT Designer3
The engineering software for MELSEC-WS and the device representation of GT Designer3
are different. Set the device by referring to the following table.
Device
*1
(1-12(Dec)): Module number
I
(1-8): Input position
*1
(1-12(Dec)): Module number
Q
(1-8): Output position
*1
LQ (0-3): Byte number
(0-7): Bit position
*1
(0-3): Byte number
LI
(0-7): Bit position
(1-2): EFI number
*1
EI
(1-3): Device number
(0-3): Byte number
*1
(1-2): EFI number
EQ
(0-2): Byte number
D
(0-99(Dec)): Byte number
(0-49(Dec)): Word number
W
Word virtualization of D device
W0= (D1(Upper bits), D0(Lower bits))
LD
(0-3): Byte number
(0-1): Word number
LW
Word virtualization of LD device
LW0= (LD1(Upper bits), LD0(Lower bits))
*1 When the mapping position is changed by the MELSEC-WS engineering software, a mismatch occurs
between virtual devices on GOT and MELSEC-WS mapping devices.
When mapping is changed, use D devices or LD devices.
GT Designer3
I .
Q .
LQ .
LI .
EI
EQ
D
W
LD
LW
Engineering software for MELSEC-WS
[ ].I
: I/O model name (such as XTIO)
(1-12(Dec)): Module number
(1-8): Input position
[ ].Q
: I/O model name (such as XTIO)
(1-12(Dec)): Module number
(1-8): Output position
.
: "Result"
(0-3): Byte number
(0-7): Bit position
[0] . .
: CPU type (CPU0, CPU1)
(0-3): Byte number
(0-7): Bit position
[0].EFI : , Byte
: CPU type (CPU0, CPU1)
(1-2): EFI number
(1-3): Device number
(0-3): Byte number
[0].EFI :1, Byte
: CPU type (CPU0, CPU1)
(1-2): EFI number
(0-2): Byte number
RS232 data
(Safety controller to RS232)
GOT independent device
(Not available)
RS232 data
(Safety controller to RS232)
GOT independent device
(Not available)