Connecting To Cpu Port/D-Sub 9-Pin Conversion Cable, Sio Port Adapter Cable - Mitsubishi Electric GOT2000 Series Connection Manual

7.2.7 Connecting to CPU port/D-sub 9-pin conversion cable, SIO port
adapter cable
■1. Setting of PLC CPU
Make the PLC CPU settings, displaying [Configuration]
tool or the ladder-programming tool.
Item
*1
Communication mode
CPU PC link function settings
*1 The communication mode that can be selected differs according to the CPU.
Set the communication mode of the CPU (transmission speed and data format).
Set the transmission speed and data format according to settings of the transmission speed, data length, parity and
stop bit on the GOT side.
For details on these GOT side settings, refer to the following.
➠
7.2.5 ■1. Setting communication interface (Communication settings)
Item
Transmission
Communication 9600
mode 0 bps
Communication 9600
mode 1 bps
Communication 19200
mode 2 bps
Communication 19200
mode 3 bps
Communication 38400
mode 4 bps
Communication 38400
mode 5 bps
Communication 57600
mode 6 bps
Communication 57600
mode 7 bps
Communication 115200
mode 8 bps
Communication 115200
mode 9 bps
Set the following when using the CPU programming port as the PC link function.
Make the checksum setting according to the sum check setting on the GOT side.
For the sum check setting on the GOT side, refer to the following.
➠
7.2.5 ■1. Setting communication interface (Communication settings)
Item
Use of PC link function
Checksum
End character
Protect function
[Communication Settings] with the program development
Set value
Transmission speed and data format
Data bit
speed
8bits Even
8bits None
8bits Even
8bits None
8bits Even
8bits None
8bits Even
8bits None
8bits Even
8bits None
Mark. (Use enabled)
Mark. (ON)
Do not mark. (OFF)
Do not mark. (OFF)
Do not mark. (OFF)
7.2 Serial Connection
Stop
Parity
bit
1bit
1bit
1bit
1bit
1bit
1bit
1bit
1bit
1bit
1bit
Set value
7 - 13
7