Ip Route Commands - Allied Telesis AT-9108 Manual

IP Route Commands

Command
config iproute add <ipaddress> <mask>
<gateway> <metric>
config iproute add blackhole <ipaddress>
<mask>
config iproute add default <gateway>
{<metric>}
config iproute delete <ipaddress> <mask>
<gateway>
config iproute delete blackhole <ipaddress>
<mask>
config iproute delete default <gateway>
config iproute priority [rip | bootp | icmp |
static | ospf-intra | ospf-inter | ospf-as-external
| ospf-extern1 | ospf-extern2 ] <priority>
disable iproute sharing
enable iproute sharing
show ipqos {<ip_destination_address>
<mask>}
show iproute {priority | vlan <name> |
permanent | <ipaddress> <mask>}
AT-9108, AT-8518, AT-8525, and AT-8550 User's Command Guide
Description
Adds a static address to the routing table. Use a value of
255.255.255.255 for mask to indicate a host entry
Adds a blackhole address to the routing table. All traffic destined
for the configured IP address is dropped, and no Internet Control
Message Protocol (ICMP) message is generated.
Adds a default gateway to the routing table. A default gateway must
be located on a configured IP interface. If no metric is specified, the
default metric of 1 is used.
Deletes a static address from the routing table.
Deletes a blackhole address from the routing table.
Deletes a default gateway from the routing table.
Changes the priority for all routes from a particular route origin.
Disables load sharing for multiple routes.
Enables load sharing if multiple routes to the same destination are
available. Only paths with the same lowest cost are shared. The
default setting is enabled.
Displays the IP QoS table.
Displays the contents of the IP routing table.
19