Power-Inline Priority - Allied Telesis x310-26FT Command Reference Manual

P E C
OWER OVER THERNET OMMANDS
-
POWER INLINE PRIORITY

power-inline priority

Overview This command sets the Power over Ethernet (PoE) priority level of a PoE port to one
of three available priority levels:
•
•
•
The no variant of this command restores the PoE port priority to the default (low).
power-inline priority {low|high|critical}
Syntax
no power-inline priority
Default The default priority is low for all PoE ports
Mode Interface Configuration
Usage This command is supported on all PoE capable ports, whether operating as a
stand-alone switch, or within a VCStack.
Select a PoE port, a list of PoE ports, or a range of PoE ports with the preceding
interface (to configure)
all be PoE capable ports.
PoE ports with higher priorities are given power before PoE ports with lower
priorities. If the priorities for two PoE ports are the same then the lower numbered
PoE port is given power before the higher numbered PoE port.
See the
about PoE priority.
C613-50103-01 REV A
low
high
critical
Parameter
low
high
critical
PoE Feature Overview and Configuration Guide
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
The lowest priority for a PoE enabled port (default). PoE ports
set to low only receive power if all the PoE ports assigned to
the other two levels are already receiving power.
The second highest priority for a PoE enabled port. PoE ports
set to high receive power only if all the ports set to critical
are already receiving power.
The highest priority for a PoE enabled port. PoE ports set to
critical are guaranteed power before any ports assigned to
the other two priority levels. Ports assigned to the other
priority levels receive power only if all critical ports are
receiving power.
command. If you specify a range or list of ports they must
for further information
640