Route Map Commands; Introduction; Chapter 29: Route Map Commands - Allied Telesis x510-28GTX Command Reference Manual

29

Introduction

Overview This chapter provides an alphabetical reference for route map commands. For
more information, see the
These commands can be divided into the following categories:
•
•
•
Command List •
•
•
•
•
•
•
•
•
•
•
•
•
C613-50170-01 Rev B
Routemaps Feature Overview and Configuration
route-map command, is used to create a route map and/or route map entry,
and to put you into route map mode
match commands, used to determine which routes the route map applies to
set commands, used to modify matching routes
"match interface" on page 1171
"match ip address" on page 1172
"match ip next-hop" on page 1175
"match ipv6 address" on page 1177
"match metric" on page 1178
"match route-type" on page 1179
"match tag" on page 1180
"route-map" on page 1181
"set ip next-hop (route
"set metric" on page 1184
"set metric-type" on page 1186
"set tag" on page 1187
"show route-map" on page 1188
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Route Map
Commands
map)" on page 1183
Guide.
1170