Table of Contents
Advertisement
P
E
C
OWER OVER
THERNET
OMMANDS
-
-
POWER
INLINE ALLOW
LEGACY
power-inline allow-legacy
Overview
This command enables detection of pre-IEEE 802.3af Power Ethernet standard
legacy Powered Devices (PDs).
The no variant of this command disables detection of pre-IEEE 802.3af Power
Ethernet standard legacy Powered Devices (PDs).
Syntax
power-inline allow-legacy
no power-inline allow-legacy
Default
Detection of legacy PDs is enabled on all ports
Mode
Global Configuration
Examples
To disable detection of legacy PDs, use the following commands:
awplus#
awplus(config)#
To enable detection of legacy PDs, use the following commands:
awplus#
awplus(config)#
Validation
show power-inline
Commands
show running-config
C613-50103-01 REV A
configure terminal
no power-inline allow-legacy
configure terminal
power-inline allow-legacy
power-inline
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
635
Advertisement
Table of Contents
