Spanning-Tree Bpdu - Allied Telesis x310-26FT Command Reference Manual

S T C
PANNING REE OMMANDS
-
SPANNING TREE BPDU

spanning-tree bpdu

Overview Use this command in Global Configuration mode to configure BPDU (Bridge
Protocol Data Unit) discarding or forwarding, with STP (Spanning Tree Protocol)
disabled on the switch.
See the Usage note about disabling Spanning Tree before using this command,
and using this command to forward unsupported BPDUs unchanged for
unsupported STP Protocols.
There is not a no variant for this command. Instead, apply the discard parameter
to reset it back to the default then re-enable STP with spanning-tree enable
command.
spanning-tree bpdu
Syntax
{discard|forward|forward-untagged-vlan|forward-vlan}
Default The discard parameter is enabled by default.
Mode Global Configuration
Usage You must first disable Spanning Tree with the
before you can use this command to then configure BPDU discarding or
forwarding.
This command enables the switch to forward unsupported BPDUs with an
unsupported Spanning Tree Protocol, such as proprietary STP protocols with
unsupported BPDUs, by forwarding BDPU (Bridge Protocol Data Unit) frames
unchanged through the switch.
When you want to revert to default behavior on the switch, issue a spanning-tree
bdpu discard command and re-enable Spanning Tree with a s panning-tree
enable command.
C613-50103-01 REV A
Parameter Description
bpdu
A port that has BPDU filtering enabled will not transmit any BPDUs
and will ignore any BPDUs received. This port type has one of the
following parameters (in Global Configuration mode):
discard
forward
forward-
untagged-
vlan
forward-
vlan
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Discards all ingress STP BPDU frames.
Forwards any ingress STP BPDU packets to all ports,
regardless of any VLAN membership.
Forwards any ingress STP BPDU frames to all ports
that are untagged members of the ingress port's
native VLAN.
Forwards any ingress STP BPDU frames to all ports
that are tagged members of the ingress port's native
VLAN.
spanning-tree enable command
568