Network Monitor Probe Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
N M
ETWORK ONITOR
This section explains the commands available for Network Monitoring Probes. Probes are stand alone
objects which help determine the status of a route based on the success or failure of probe traffic across the
path. The probes can be configured to trigger at particular intervals. There are three types of probes
supported by SROS: ICMP echo, TCP connect, and HTTP request. Commands common to all the probe
types are identified in the following section as well as isolated commands that only apply to the specific
probe types.
Additional configuration commands are available for associating tracks with each probe. These are
explained in the Network Monitor Track Configuration Command Set on page 1347.
To activate the Network Monitor Probe Configuration mode, enter the probe command at the Global
Configuration mode prompt followed by the probe name. Specify the probe type of icmp-echo,
tcp-connect, or http-request. For example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#probe probe1 icmp-echo
ProCurve(config-probe-probe1)#
The following command is common to multiple command sets and covered in a centralized section of this
guide. For more information, refer to the section listed below:
do on page 1435
exit on page 1437
The following commands are applicable to ICMP echo probe types and can be executed after this
command:
ProCurve(config)#probe <probe name> icmp-echo
data <pattern> on page 1333
destination on page 1334
period <value> on page 1337
shutdown on page 1339
size <data length>
source-address <ip address>
timeout <value> on page 1343
tolerance on page 1344
5991-2114
P C
ROBE
on page 1340
on page 1341
© Copyright 2007 Hewlett-Packard Development Company, L.P.

Network Monitor Probe Command Set

S
OMMAND ET
1330